I've installed the K2 on my BMW R 1200 GS 2015, since about 3 weeks now.
Clean installation, wires routed following the motorbike's original cabling, unit under the passenger's seat, place not getting hot, unit fixed with absorbing foam tape to avoid vibrations.
Sometimes the unit works as expected.
But sometimes, when it receives the switched signal, it enters a mode where the LEDs are blinking as illustrated in the attached video K2_outoforder.MOV.
When in this mode, cannot connect through WIFI and recording does not start of course...
More problematic, even when switching off the motorbike, the K2 unit stays indefinitely in this mode, draining the motorbike's battery!
After 2 days, the motorbike indicated low battery. Fortunately, it was able to start, but imagine if it has stayed in this mode for many weeks...
When the unit starts correctly, the recording works fine for the rear camera.
The front camera sometimes starts recording correctly, then after a while, it continues recording, but a frozen image. The audio of the recording is still OK, the GPS info as well, but image frozen, until the next power OFF/ON.
See the attached video K2_frontcam_freeze.mp4.
The park mode is not enabled in my settings.
However, sometimes, the K2 starts recording while the motorbike is parked since few hours, and records for hours, for nothing.
The first video file showing nothing happening around the motorbike, to justify the start of recording...
This one is annoying not only because it fills the card with unwanted videos, deleting old ones which I may want to keep, but it drains again the motorbike's battery...
I use a brand new original high quality SanDisk Ultra microSDXC C10 card, but I've tried also other ones, without noticing any difference.
So "no", it's not because of the microSD card...
As a conclusion, my K2 unit is more or less working, but not reliable at all, which is really too bad...
Do you have similar issues with yours?
Can the INNOVV Support help me there?