Hi guys, just refitted my K2 on 2020 bmw 1250 gsa, old bike was straight to battery but fitted a hex ezcan on new bike, followed all popular intstall guides, it was all straight forward, chose to power and switch via ezcan, all went well but I am experiencing errors on the ezcan and I have to switch to another one of the power cords to get it to start up again, works fine and all is good until the bike is switched off a wee while and then it red errors on ezcan, good soldered joints, can’t understand what’s happening. Set up as accessory on ezcan with 2amp fuse and 30s shutdown, any advice welcome.
top of page
bottom of page
Hello Frooter,
Here is how to connect the K2 on a Hex ezcan,
https://youtu.be/drsFH7t7F_w
https://youtu.be/LtCrQMtzkTY
Hope it will help.